Tech Talk – Terminator Waterproofing

January 5, 2017 at 6:32 a.m.

Terminator 622 is a powerful sealant that will even cure under water and is the topic of this episode of American WeatherStar's Tech Talk

In this episode of Tech Talk, Eric demonstrates a new product was introduced this summer: Terminator 622. Terminator 622 is a 100% solids moisture cured sealant that adheres to every substrate it’s been tested it on including fluid-applied system. Our testing even shows great adhesion to silicone.

Watch this demonstration to see Terminator 622 going down on a wet substrate and then curing while under water.

Product Description AWS Terminator 622 is a technologically advanced, 100% solids, moisture cure sealant/adhesive. This high-strength versatile product has excellent elasticity and adhesion, making it ideal for repairs. Designed for industrial use, it can be applied to most surfaces even when the area is wet. Not only is it waterproof, it is UV stable and low VOC.

The thicker version, 624XT is best for use on walls and other areas where sagging is not an option.

Advantages

Self-leveling technology for all seams, fasteners, ridge caps, flashings, and penetrations.
Moisture curing multi-purpose one-component sealant/adhesive
Designed for industrial uses requiring elasticity, high strength, and excellent adhesion.
May be applied to surfaces at or below freezing temperatures. Make all attempts to remove frost.
Performance at temperatures as low as -40 degrees f.
Bonds to damp surfaces and is rain tolerant during cure.
Cures to a waterproof tough flexible sealant.
Low odor and minimal shrinkage.
Non-staining and mildew resistant.
UV resistant.
VOC compliant.

Basic Uses Industrial uses requiring high elasticity, high-strength and outstanding adhesion for a wide-range of substrates AWS Terminator 622 bonds aggressively to steel, aluminum, modified bitumen, built-up roofing, spray foam, styrofoam, eps, glass, wood, fiberglass, concrete and coated metals.

Installation All surfaces must be cleaned properly. Any existing coating must be checked for good adhesion. Before application, any loosely adhered coating must be removed and bare surfaces must be prepared, cleaned and checked for compatibility. AWS Terminator 622 is ready to use.

Brush: Good quality synthetic bristle brush.
Caulk Gun: 28-fluid-ounce cartridges

For more information, visit www.americanweatherstar.com